Chipblaster Jv10 Manual !full! Online

The you are running (water-soluble, synthetic, or straight oil)

The Chipblaster JV10 is a high-performance, high-pressure coolant system designed for machining applications. Here are some details about the manual:

Never service hoses, filters, or fittings while the unit is pressurized or running. Turn off the main power and allow the pressure gauge to drop completely to zero.

The ChipBLASTER JV10 automatically matches its coolant flow to the size of the machine tool's orifice. By delivering the exact amount of coolant required, it eliminates energy waste and prevents excess heat generation in the sump. Key Specifications 1,000 PSI (70 bar) Maximum Flow Rate: 10 GPM (38 LPM) Motor Power: 7.5 HP (standard configuration) chipblaster jv10 manual

Never use flammable or explosive fluids inside or near the machinery. Only aqueous solutions or approved cutting oils should be utilized.

Ensure the CNC machine coolant tank is filled to its optimal operating level. Command the high-pressure M-code in your CNC program.

If your system is equipped with dual bags, switch the isolation ball valve from the dirty canister to the clean alternative to sustain operations. The you are running (water-soluble, synthetic, or straight

Switch the main breaker disconnect on the JV10 electrical cabinet to the position.

Remove and clean the coarse suction strainer in the supply tank.

: Wire the system directly from a dedicated power bus. Verify the supply line handles the high amperage draw (KVA) specified on the serial plate. The ChipBLASTER JV10 automatically matches its coolant flow

Inspect the JV10 filter pressure gauges to ensure filters are clean.

Require higher pressure (800–1000 PSI) and low volume.

: Usually found in the back of the physical manual, essential for troubleshooting PLC communication errors with the CNC.