Decastar 150e Manual Top

These switches control the heat output. Lower numbers are for thinner metal; higher numbers are for thicker metal.

Routine care extends the lifespan of your torch consumables and drive motor. Consumable Care decastar 150e manual top

Supports steel, stainless steel, and aluminum (0.6–1.0 mm wire) when used with appropriate shielding gas like Argon or cap C cap O sub 2 Safety Features: These switches control the heat output

Flip the tension arm off the drive roller. Recommended Settings for 3mm Steel If the machine

Tip: A good starting point for 0.8mm wire is to set the knob in the middle range (e.g., 4 or 5) and adjust from there. C. Recommended Settings for 3mm Steel

If the machine stops, the Duty Cycle has been exceeded. Let the fan run for 5-10 minutes while the machine cools down. 5. Frequently Asked Questions (FAQ)

While specific settings depend on material thickness, use these general guidelines for the DECASTAR 150E. Recommended Wire Shielding Gas 0.6mm - 0.8mm Solid CO2 or Argon/CO2 Mix Stainless Steel 0.8mm Stainless Argon + 1-2% Oxygen Aluminium 0.8mm - 1.0mm Almg/Alsi Pure Argon Outdoor Steel 0.9mm Flux-Cored None (Self-Shielded) Safety and Maintenance Tips Decastar - Weld Talk Message Boards