The is a critical tool for automotive technicians, enabling the reading and writing of data from various memory chips, such as the 35080 and 160D0WQ series. It is specifically designed to interface with the iProg+ Pro Programmer to perform tasks like odometer correction, airbag resets, and immo pin code extraction. Core Pinout and Wiring
Note: iPROG has multiple firmware modes (I²C, SPI, MicroWire). Pin functions change depending on protocol selected in software.
However, the magic of the iPROG does not lie in the box alone; it lies in the connection between the programmer and the target chip. This is where the becomes critical. If you are searching for "iprog eeprom adapter pinout portable," you likely own (or are considering) this tool and need to understand how to wire it correctly for various chip families without being tethered to a bulky lab setup.
The is a specialized diagnostic accessory designed for the iProg+ Pro universal programmer. It is primarily used by automotive technicians for reading, writing, and erasing serial EEPROM chips found in vehicle ECUs, immobilizers, and dashboard modules. Key Adapter Capabilities iprog eeprom adapter pinout portable
If you are using a or a soldering-free probe kit The version of iProg you have (V84, V87, etc.)
Frequently used in Toyota, Lexus, and Honda immobilizer units and dashboards. Chip Select Pin 2 (SK): Serial Clock Pin 3 (DI): Data Input Pin 4 (DO): Data Output Pin 5 (GND): Ground Pin 6 (ORG): Organization (8-bit or 16-bit mode selection) Pin 7 (PE): Program Enable Pin 8 (VCC): Power Supply Building a Portable EEPROM Clip Setup
The iProg is a multifunctional, portable programming tool used for vehicle electronic modules, EEPROM, IMMO, and related tasks. Many technicians use compact, adapter-based setups to read/write EEPROM chips outside the circuit board or in-circuit with a clip. This essay summarizes common EEPROM adapter pinouts for portable use, wiring practices, and safety/operational tips. The is a critical tool for automotive technicians,
Do you need the for a specific clone version or original iProg hardware? Share public link
Execute a read command within the iProg software.
The system relies on a set of adapters to interface with different modules. A standard iProg set typically includes an EEPROM adapter, a UART/BDM adapter, a CAN adapter, a K-Line adapter, RFID adapters, and various cables. The physical hardware connects to a PC via a USB cable. Notably, the iProg+ version draws power solely from the USB port at 5V. Using an external 12V power supply can permanently damage the device, a common issue with some clones that users have reported overheating and burning out on. Pin functions change depending on protocol selected in
: Typically indicates no connection is required for that specific task. Portable Design Specifications
Applying 5V to a dedicated 3.3V variant will permanently degrade or destroy the silicon structure. 2. USB Bus Power Management
: When using a clip in-circuit, ensure the onboard MCU isn't holding the reset line or loading down the clock lines. If the read fails consistently, you must desolder the chip and place it directly onto the adapter ZIF socket.
It is designed for various serial EEPROMs including MW (93C46-93C86), I2C (24C00-24512), and SPI (25010-25512). Usage Tips for Technicians