Radiowaves at 60 kHz (the WWVB frequency) can be easily blocked or disrupted by modern household environments. To guarantee a strong, reliable connection:
Forces the clock to immediately stop regular timekeeping and search for the atomic radio signal. Press and hold this for 3 seconds if you want to test reception.
The clock will continue to try and catch the signal to adjust itself periodically. 4. Troubleshooting Your Kincaid Radio Controlled Clock
The screen will light up, display full segments, and a tower/wave icon will begin flashing. This flashing icon indicates it is actively searching for the atomic time signal. Step 3: Time Zone Selection kincaid radio controlled clock instruction manual
A weak signal has been detected. The clock may take a long time to synchronize or may fail if interference increases.
Kincaid Radio Controlled Clock Instruction Manual: The Complete Setup & Troubleshooting Guide
| Problem | Most Likely Cause | Solution | | :--- | :--- | :--- | | | Dead batteries or incorrect polarity. | Insert fresh, high-quality alkaline batteries and double-check the (+) and (-) symbols match. | | The clock is not showing the correct time. | Poor signal reception. | Move the clock closer to a window, away from electronics. If the problem persists, press the RESET button with a paperclip. | | The hands are stuck or not moving. | Temporary mechanical jam. | Remove the batteries, press and hold the RESET button for 5 seconds, then reinsert the batteries. | | The clock is an hour off (e.g., 1:00 vs 2:00). | The Daylight Saving Time or Time Zone setting is incorrect. | Check the DST switch/setting and the Time Zone switch/setting on the back of the clock. | | The hands spin continuously in circles. | Normal synchronization behavior. | This is normal. The hands are spinning to the factory default position (often 12:00) to prepare for signal reception. Let it finish. | Radiowaves at 60 kHz (the WWVB frequency) can
: Stop pressing the button when the correct time is reached; the clock will exit manual mode after a few seconds of inactivity. Troubleshooting & Maintenance Hands Spinning Randomly : This usually indicates a low battery
: If the clock doesn't set after 12 minutes, move it to a different location away from electronics like TVs or computers, which can cause interference.
Replace all batteries with brand-new, premium alkaline batteries. Press the RESET button using a paperclip after insertion to clean out any system cache errors. The clock will continue to try and catch
Kincaid Radio Controlled Clock Instruction Guide Kincaid radio controlled (atomic) clocks are designed to automatically synchronise with a time signal transmitted from an atomic clock (such as the WWVB signal in Colorado for North America). This guide provides standard procedures for setting up, manually adjusting, and troubleshooting these timepieces. 1. Initial Setup and Automatic Synchronization
The clock requires a clear path to the Colorado radio tower.
To set up your clock, follow these steps: